Firebird V8-5.7L VIN G (2001)
6. Install the J 41476 and bolts onto the rear of the crankshaft.
Notice: Refer to Fastener Notice in Service Precautions.
7. Tighten the J 41476 bolts until snug. Do not overtighten.
7.1. Tighten the oil pan-to-rear cover bolts to 12 Nm (106 inch lbs.).
7.2. Tighten the engine rear cover bolts to 25 Nm (18 ft. lbs.).
8. Remove the J 41476.
Important:
-
Do not lubricate the oil seal Inside Diameter (ID) or the crankshaft surface.
-
Do not reuse the crankshaft rear oil seal.
9. Lubricate the Outside Diameter (OD) of the oil seal (1) with clean engine oil.
Do not allow oil or other lubricants to contact the seal surface.
10. Lubricate the rear cover oil seal bore with clean engine oil.
Do not allow oil or other lubricants to contact the crankshaft surface.
