Firebird V8-5.7L VIN G (2001)
6. Remove the front cover and gasket.
7. Discard the front cover gasket.
8. Clean and inspect the engine front cover.
Installation Procedure
Important:
-
Do not reuse the crankshaft oil seal or front cover gasket.
-
Do not apply any type sealant to the front cover gasket (unless specified).
-
The special tool in this procedure is used to center the crankshaft front oil seal.
-
All gasket surfaces should be free of oil or other foreign material during assembly.
-
The crankshaft front oil seal MUST be centered in relation to the crankshaft.
-
An improperly aligned front cover may cause premature front oil seal wear and/or engine oil leaks.
1. Apply a 5 mm (0.20 inch) bead of sealant GM P/N 12378190 or equivalent 20 mm (0.80 inch) long to the oil pan to engine block junction.
2. Install the front cover and gasket.
3. Install the front cover bolts until snug. Do not overtighten.
4. Install the oil pan-to-front cover bolts until snug. Do not overtighten.
