Firebird V8-5.7L VIN G (2001)
IMPORTANT: The fuel pump strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender
assembly, assure that the fuel pump strainer does not block full travel of the float arm.
2. Install the fuel sender assembly into the fuel tank.
3. Install the fuel sender assembly retaining ring using the J 39765.
4. Perform the fuel tank leak check. Refer to fuel tank leak check.
5. Connect the fuel sender electrical connectors (1) to the fuel sender.
6. Connect the fuel feed pipe (4), the fuel return pipe (2), and the EVAP pipe (3) to the fuel sender.
7. Install the fuel tank.
8. Refill the fuel tank.
9. Install the fuel filler cap.
10. Connect the negative battery cable.
11. Inspect for leaks.
11.1. Turn ON the ignition for 2 seconds.
11.2. Turn OFF the ignition for 10 seconds.
