Firebird V8-5.7L VIN G (2001)
Child Seat Tether Attachment: Service and Repair
Child Restraint Belt Anchor Bracket Intallation
IMPORTANT: All vehicles are equipped with drilled and tapped plates welded to the rear compartment front panel. These plates serve as mounting
points for the Child Seat Restraint System Belt Kits. If an anchor bracket (1) is being installed for the first time, use the following procedure:
1. Remove the cargo area side trim panel.
2. Carefully lift the rear edge of the carpeting in order to reveal the anchor bracket mounting plate locations.
3. Choose the mounting location on either the driver side or the passenger side.
4. Position the anchor bracket (1) to the anchor bracket mounting plate.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: DO NOT use a nut driver to tighten this hardware or the fasteners will not be properly seated.
5. Install the bolts.
Tighten
Tighten the bolts to 42 N.m (31 lb ft).
6. Replace the carpeting.
Note the bump created by the anchor bracket.
IMPORTANT: Pull the carpet tight before making a cut in the carpet.
7. Carefully slit the carpeting to allow the anchor bracket to protrude.
8. Follow the instructions in the owner's manual and the product information accompanying the child seat regarding the positioning and installation
of the child seat when the rear safety belts are used.
