G5 L4-2.2L (2007)
3. Glue the bumper to the inside of the dust boot (shield) as shown. Use *3M(TM) Duramix(TM) Super Fast Adhesive, P/N 04747. Allow to cure
thoroughly 5-10 minutes at room temperature.
4. Apply a light coat of *3M(TM) Automotive Adhesion Promoter, P/N 06396, to the top of the dust boot (shield) and to the upper spring seat
surface. Allow to dry 10 minutes.
5. Glue the dust boot (shield) to the upper spring seat as shown using the above recommended adhesive. Allow to cure thoroughly.
*We believe this source and their products to be reliable. There may be additional manufacturers of such products. General Motors does not endorse,
indicate any preference for or assume any responsibility for the products from this firm or for any such items which may be available from other sources.
Parts Information #2
For part numbers and usage of the strut, see Strut Kit in Group 07.345 of the appropriate Parts Catalog.
Warranty Information #2
For vehicles repaired under warranty, use:
Condition #3
Some customers may comment on a clunk/pop type noise coming from the front of the vehicle when driving over rough road surfaces.
Cause #3
This noise may be caused by the stabilizer shaft link ball stud becoming contaminated from moisture.
Correction #3
Inspect the front stabilizer shaft links for damage. To isolate the noise, the link can be also be disconnected from the stabilizer shaft. If the link appears
damaged or if the noise goes away when disconnected, replace the link with the revised part.
Parts Information #3
