G5 L4-2.2L (2007)
19. Remove the brake caliper from the caliper bracket.
20. Inspect the brake caliper guide pins for freedom of movement, and inspect the condition of the guide pin boots. Move the guide pins inboard and
outboard within the bracket bores, without disengaging the slides from the boots, and observe for the following:
*
Restricted caliper guide pin movement
*
Looseness in the brake caliper mounting bracket
*
Seized or binding caliper guide pins
*
Split or torn boots
21. If any of the conditions listed are found, the brake caliper guide pins and/or boots require replacement.
Installation Procedure
1. Install the brake caliper to the caliper bracket.
Notice: Refer to Fastener Notice.
2. While using a wrench on the flats of the caliper guide pins (1), install the brake caliper guide pin bolts (2).
Tighten the bolts to 34 N.m (25 lb ft).
3. Press the park brake cable end fitting into the bracket on the caliper to secure the retaining tabs (4).
4. Secure the park brake cable end (1) to the lever on the caliper.