G5 L4-2.2L (2007)
Important: Spraying the heater core seal and the dashmat with a soap and water mixture will ease installation.
2. Install the heater core cover from the right side. Slide up and forward into position. Align the drain tube with the hole in the front of dash. Raise
the heater core cover into position while aligning holes with the locating pins from the HVAC module.
3. Cut the sound insulator at the cowl near the center screw (1) approximately 76 mm (3 in) and fold the sound insulator back to ease in installation
of the screw.
Ensure the sound insulator is positioned back after the screws are tightened.
Notice: Refer to Fastener Notice.
Important: Make certain that the heater core cover is properly positioned and is fully seated on the HVAC module before installing the
screws. Be sure to install all heater core cover screws.
4. Install the heater core cover screws.
Tighten the heater core cover screws to 1.8 N.m (15 lb in).
5. Install the stud into the dash panel at the heater hoses and tighten the nut that is behind the fuel line bracket.
