G5 L4-2.2L (2007)
Backup Lamp Switch: Service and Repair
Backup Lamp Switch Replacement
Removal Procedure
Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch
assembly.
1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5 Lug
Wheel).
2. Disconnect the backup lamp connector (1).
3. Remove the backup lamp switch assembly.
Installation Procedure
Notice: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch
assembly.
Notice: Refer to Fastener Notice.
1. Install the backup lamp switch. using pipe sealant Saturn P/N 21485278 or equivalent.
Tighten the switch to 33 N.m (24 lb ft).
2. Connect the backup lamp connector (1).
3. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5 Lug
