G5 L4-2.2L (2007)
Evaporative Emissions Hose: Service and Repair
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine/Chassis
Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis
Removal Procedure
1. Disconnect the EVAP purge pipe from the engine purge hose.
2. Cap or plug the purge pipe and the engine purge hose to prevent contamination.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the evaporative emission (EVAP) canister for pipe removal access.
5. Remove the rear brake pipe bracket retaining nuts and release the brackets from the body studs.
6. Release the pipe retainers (1) from the vehicle underbody.
7. Remove the purge pipe from the pipe retainers.
8. Lower the rear of the pipe while moving the pipe rearward slightly, then lower the front of the pipe.