pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Manifold Pressure/Vacuum Sensor > < Diagram Information and Instructions|Page 1447
Page 1
background image

Knock Sensor: Service and Repair

Knock Sensor Replacement

Removal Procedure

1. Remove the starter.

2. Disconnect the knock sensor (KS) harness connector.
3. Remove the KS retaining bolt.
4. Remove the KS.

Installation Procedure

Notice:  Refer to Fastener Notice.

Important:  The KS threaded surfaces must be clean before installation.

1. Install the knock sensor.

Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).

2. Connect the knock sensor harness connector.
3. Install the starter.

Manifold Pressure/Vacuum Sensor > < Diagram Information and Instructions|Page 1447