G5 L4-2.2L (2007)
Oxygen Sensor: Service and Repair
Heated Oxygen Sensor 2 Replacement
Heated Oxygen Sensor 2 Replacement
Tools Required
J 39194-C Oxygen Sensor Wrench
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel drive shaft heat shield.
3. Note the routing of the heated oxygen sensor (HO2S) electrical harness.
4. Disconnect the HO2S electrical connector (2), in the engine compartment.
5. Carefully bend the edge of the channel on the LH side of the exhaust heat shield outboard, just enough to release the HO2S electrical harness (1).
Notice: Refer to Heated Oxygen and Oxygen Sensor Notice.
Notice: Refer to Excessive Force and Oxygen Sensor Notice.
6. Using the J 39194 carefully remove the HO2S.
7. Lower the HO2S electrical harness away from the underbody.
Installation Procedure
Important: A special anti-seize compound is used on the HO2S threads. The compound consists of a liquid graphite and glass beads. The
