G5 L4-2.2L (2007)
Using Fused Jumper Wires
USING FUSED JUMPER WIRES
TOOLS REQUIRED
J 36169-A Fused Jumper Wire
IMPORTANT: A fused jumper may not protect solid state components from being damaged.
The J 36169-A includes small clamp connectors that provide adaptation to most connectors without damage. This fused jumper wire is supplied with a
20-A fuse which may not be suitable for some circuits. Do not use a fuse with a higher rating than the fuse that protects the circuit being tested.
AFL/ECP Connectors
AFL/EPC CONNECTORS
TOOLS REQUIRED
J-38125 Terminal Repair Kit
REMOVAL PROCEDURE
Follow the steps below in order to remove terminals from the connector.
1. For connectors with a bolt in the dress cover, turn the bolt counterclockwise to remove the connector from the component.
