G5 L4-2.2L (2007)
8. Insert the J 38125-213 into the small terminal release hole on the nose piece and gently pull on the back of the wire.
9. See the release tool cross reference in the Reference Guide of the J-38125 Terminal Repair Kit to ensure that the correct release tool is used.
TERMINAL REPAIR PROCEDURE
Refer to the terminal crimping procedure in the Reference Guide of the J-38125 Terminal Repair Kit.
TERMINAL REPLACEMENT PROCEDURE
After the terminal is crimped to the wire, perform the following procedure in order to replace the terminal.
1. Slide the new terminal into the correct cavity at the back of the connector.
2. Push the terminal into the connector until it locks into place. The new terminal should be even with the other terminals. Insure that the terminal is
locked in place by gently pulling on the wire.
3. To assemble the connector, reverse the connector disassembly procedure.
Pull to Seat Connectors
PULL TO SEAT CONNECTORS
TERMINAL REMOVAL
If the terminal is visibly damaged or is suspected of having a faulty connection, the terminal should be replaced.
Follow the steps below in order to repair pull-to-seat connectors:
