G5 L4-2.2L (2007)
6. If repairs were made in Steps 3-5, install the seat in the vehicle and reconnect the seat harness to the vehicle harness.
7. With the ignition on and the engine OFF, clear the SDM and PPS codes.
8. Cycle the ignition and verify that the codes are cleared.
9. If active codes return, replace the PPS (3), Refer to Inflatable Restraint Passenger Presence System Replacement in SI.
PPS DTC 065 - Sensor Circuit Out of Range
1. Remove the seat (2). Refer to Front Seat Replacement - Bucket in SI
2. Check if seat harness is cut, chafed or shorted. Repair as necessary.
3. With a DMM, measure for shorts between all three wires leading from the sensor mat connector to the ECU connector. Repair as necessary.
4. If repairs were made in Steps 2-3, go to Step 10.
5. Check for a cut, chafed or shorted BTS pigtail. Repair as necessary.
6. With a DMM, measure for shorts on the three wires leading from the BTS connector (vehicle harness side) to the ECU. Repair as necessary.
7. If repairs were made in Steps step 5-6, reconnect the BTS.
8. Install the seat (2) in the vehicle and reconnect the seat harness to the vehicle harness. Refer to Front Seat Replacement in SI.
9. With the ignition on and the engine OFF, clear the SDM and PPS codes.
10. Cycle the ignition and verify that the codes are cleared.
11. If active codes return, replace the PPS (3), Refer to Inflatable Restraint Passenger Presence System Replacement in SI.
Parts Information
Warranty Information
For repairs performed under warranty, use the applicable published labor code from the Labor Time Guide.
Disclaimer
