G5 L4-2.2L (2007)
Stabilizer Bar Bracket: Technical Service Bulletins
Suspension - Alternate Anti-Sway Bar Clamp Procedure
Bulletin No.: 07-03-08-007
Date: September 28, 2007
INFORMATION
Subject:
Alternate Anti-Sway Bar Clamp Service Procedure
Models:
2005-2007 Chevrolet Cobalt
2005-2006 Pontiac Pursuit (Canada Only)
2007-2008 Pontiac G5
Attention:
This procedure is only to be performed as a customer pay.
Front Sway Bar Mounting Clamp Service Procedure
This is to inform dealers of an optional service procedure for front sway bar mounting clamps that is only to be performed at the owner's expense. This
procedure requires the removal of the existing engine cradle and sway bar mounting clamps.
These parts should be replaced with the parts listed in the table under Parts Information.
Replacement Procedure
The following service replacement instructions can be found in SI. Remove the vehicle frame and replace with the part number listed below. Install the
new anti-sway bar clamps.
Sway Bar Insulator Removal (FE1/FE3)
Sway Bar Insulator Removal (FE5)
Frame Replacement
Parts Information
Warranty Information
The above modifications are considered to be a customer option and should be performed at the customer's expense. Should your vehicle be used for
racing or other competitive driving, refer to your vehicle warranty book or your General Motors dealership for information on the General Motors New
Vehicle Limited Warranty and how racing and competitive driving may affect your warranty.
