G5 L4-2.2L (2007)
Tighten the nuts to 45 N.m (33 lb ft) plus 30 degrees.
3. Connect the electrical connector to the wheel speed sensor.
4. Install the brake rotor, and install the brake caliper and bracket as an assembly. Refer to Rear Brake Rotor Replacement.
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5
Lug Wheel).
6. Lower the vehicle.
Wheel Bearing/Hub Replacement - Rear (Drum Brake)
Wheel Bearing/Hub Replacement - Rear (Drum Brake)
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation
(5 Lug Wheel).
3. Remove the brake drum. Refer to Brake Drum Replacement.
4. Remove the plug from the drum brake actuator access hole in the backing plate. Using the access hole, install a support (1) for the brake backing
plate.
5. Disconnect the electrical connector (2) from the wheel speed sensor, if equipped with ABS.
6. Remove the wheel bearing/hub assembly mounting nuts (3).
7. Remove the wheel bearing/hub assembly from the rear axle assembly and brake backing plate.
Installation Procedure
