G5 L4-2.2L (2007)
20. Remove the transmission side cover lower bolts.
21. Remove the transmission side cover.
Installation Procedure
1. Install the transmission side cover.
Notice: Refer to Fastener Notice.
2. Hand start the transmission side cover lower bolts.
Tighten the side cover bolts and stud to 20 N.m (15 lb ft).
3. Lower the vehicle.
4. Raise the engine with the engine support fixture.
5. Raise the vehicle.
6. Install the transmission mount. Refer to Transmission Front Mount Replacement or Transmission Rear Mount Replacement.
7. Install the frame. Refer to Frame Replacement.
8. Install the power steering gear mounting bolts. Refer to Power Steering Gear Replacement.
9. Install the wheel drive shaft to the transmission. Refer to Wheel Drive Shaft Replacement.
10. Connect the left ball joint to the steering knuckle. Refer to Lower Ball Joint Replacement (with FE1 Only).
11. Install the left inner fender liner. Refer to Front Fender Liner Replacement.
12. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5
Lug Wheel).
13. Lower the vehicle.
14. Remove the engine support fixture. Refer to Engine Support Fixture.
15. Install the PNP switch. Refer to Park/Neutral Position Switch Replacement.
