G5 L4-2.2L (2007)
Fluid Filter - A/T: Service and Repair
Automatic Transmission Fluid Filter and Seal Replacement
Tools Required:
-
J 6125-1B Slide Hammer
-
J 23129 Axle Boot Remover
Removal Procedure
Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is
supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to
the hoist.
1. Raise and support the vehicle.
2. Place the drain pan under the transaxle oil pan.
Notice: When removing the oil pan bolts, be careful not to damage the oil pan sealing surfaces. Such damage may result in oil leaks in this area.
3. Remove the oil pan bolts from only the front and the sides.
4. Loosen the rear oil pan bolts about 4 turns.
5. Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
6. Inspect the fluid color.
7. Remove the remaining oil pan bolts.
8. Remove the oil pan.
