G5 L4-2.2L (2007)
1. Use the J 41102-1A and a mallet in order to install the new case cover seal.
2. Use the J 41228 in order to install a new sleeve on the output axle. Install the J 41228 so that the collar is in the snap ring groove.
3. Install the axle shaft retaining clip onto the output axle.
4. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement.
5. Lower the vehicle.
6. Inspect the shaft sleeve for leaks.
7. Inspect the transmission oil level. Refer to Transmission Fluid Checking.
