G5 L4-2.2L (2007)
1. Make sure the transaxle manual shaft is in the Neutral position.
2. Align the flats on the transaxle shift shaft with the flats on the transaxle range switch and install the switch.
Notice: Refer to Fastener Notice.
3. Tighten the transaxle range switch bolts.
Tighten the range switch bolts to 20 N.m (15 lb ft).
4. Install the transaxle range switch lever and nut.
Tighten the transaxle range switch lever retaining nut to 35 N.m (26 lb ft).
5. Connect the transaxle range switch electrical connector.
Important: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust
the switch.
6. Install the shift control cable to transaxle range switch lever and verify proper operation.
