G5 L4-2.2L (2007)
6. Place a brass drift against the CV joint cage (1).
7. Tap gently on the brass drift with a hammer in order to tilt the cage (1).
8. Install the first chrome alloy ball (2) when the CV joint cage (1) tilts.
9. Repeat this process to install all 6 balls.
10. Pack the CV joint with half of the grease supplied in the service kit.
11. Install the new swage ring (2) on the neck of the seal (3). Do not crimp.
12. Clean the shaft (1). Use a wire brush to remove any rust in the seal mounting area (grooves).
13. Slide the CV joint seal (3) onto the shaft (1). Expose the reference mark (4) by sliding the CV joint seal (3) up the shaft (1) toward the tripot end.
