G6 L4-2.4L (2007)
Noise over bumps from the rear upper quarter panel (either side of vehicle).
Cause 3
Rear quarter panel metal may be creaking.
FOR VEHICLES BUILT PRIOR TO 10/30/2006
Take precaution not to damage the outer sheet metal.
Remove the rubber seal from the top of the quarter panel and slightly move the inner sheet metal away from the outer sheet metal.
Condition 3A
Creaking/popping noise over bumps from the rear of the door (either side of vehicle).
Cause 3A
The door spring pin may be out of adjustment or frozen.
Correction 3A
Adjust the receiver to pin and lubricate the door spring pin.
Condition 3B
Deck lid area metal creak/pop noise over bumps (either side of vehicle).
Cause 3B
This noise may be caused by the stand-off bracket making contact with the paint.
PROCEDURE FOR VEHICLES BUILT PRIOR TO 04/03/2006
Adjust the deck lid stand-off bracket and install a piece of mylar tape to cover the paint area. Use alcohol to clean the area.
Condition 4
Noise from roof seals.
Cause 4
The seal may be dry and making a noise.
Correction 4
