G6 L4-2.4L (2007)
If the rear sunroof drains are routed and connected properly proceed to Step 12.
If the rear sunroof drains are not routed and connected properly reroute and connect them as instructed in this service procedure. Refer to Step 10.
Do not kink the hose when rerouting. Disconnect the hose from the two retaining clamps and carefully reroute correctly.
If either of the rear drain hoses have come loose or are routed incorrectly, reroute them correctly. The drain hoses should be routed to the outside of the
coat hook retainers. Install an tube, P/N 25930220 (2 per vehicle) onto the end of each green rubber coupling, located at the rear of the sunroof module
(one per side [two total]). Slide the rear drain hose into the other end of the new extension hose and secure the clamps to the drain hose.
Clamp the new extension hose by installing a tie strap around the green rubber couplings (both sides - rear).
Verify that the two front drain hoses are properly attached.
If the drain hoses are not attached properly, attach and secure them with a tie strap. Trim the tie straps to avoid creating a headliner itch noise.
If the drain hoses are attached properly secure them with a tie strap. Trim the tie straps to avoid creating a headliner itch noise
Install the sunshades. Refer to Sunshade Replacement Convertible in SI.
Install the sunshade retainer bezel. Refer to Sunshade Retainer Bezel Replacement Convertible in SI.
Install the rubber weatherstrip around the sunroof opening.
Install the windshield pillar garnish molding. Refer to Windshield Pillar Garnish Molding Replacement in SI.
Remove the left and right seat belt pivot bolt and trim.
Install the coat hooks.
Install the center pillar upper garnish molding. Refer to Center Pillar Upper Garnish Molding Replacement in SI.
Install both primary door seals.
