G6 L4-2.4L (2007)
Sunroof / Moonroof Motor: Procedures
Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor)
SUNROOF MOTOR/ACTUATOR INITIALIZATION/TEACH PROCESS (EXISTING MOTOR)
Perform the Initialization/Teach Procedure any time the sunroof motor/actuator is removed from the sunroof.
1. Ensure that the electrical harness on the headliner is connected to the sunroof.
2. Press the sunroof switch to the open position until the window stops at the rear soft stop in the fully open position. Release the switch.
3. Press and hold the switch in the open position for 10 seconds or more. The sunroof will stall at the hard stop and move back slightly to the soft
stop position. Release the button.
4. Within 6 seconds, press and hold the open switch. After an additional 3 seconds, the sunroof window will move toward the close position.
5. Hold the switch until the sunroof window stops at the closed position. Release the switch.
6. Verify the operation of the sunroof.
IMPORTANT: The Initialization/Teach Procedure is not complete if any of the following actions take place before the initialization cycle is done:
-
The sunroof switch is not held in the open position.
-
The ignition and/or battery power has been removed.
-
The glass panel has not reached the closed position.
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
Sunroof Motor/Actuator Initialization/Teach Process (New Motor)
SUNROOF MOTOR/ACTUATOR INITIALIZATION/TEACH PROCESS (NEW MOTOR)
Perform the Initialization/Teach Procedure any time a new sunroof motor actuator is installed in the vehicle.
1. Ensure that the electrical harness on the headliner is connected to the sunroof.
2. Press the sunroof switch to the open position until the window stalls at the rear hard stop in the fully open position, then moves slightly toward the
soft stop position. Release the switch
3. Within 6 seconds, press and hold the open switch. After an additional 3 seconds, the sunroof window will move toward the close position.
4. Hold the switch until the sunroof window stops at the closed position. Release the switch.
5. Verify the operation of the sunroof.
IMPORTANT: The Initialization/Teach Procedure is not complete if any of the following actions take place before the initialization cycle is done:
-
The sunroof switch is not held in the open position.
-
The ignition and/or battery power has been removed.
-
The glass panel has not reached the closed position.
The Initialization/Teach Process must be restarted if the procedure is not carried out completely.
Sunroof Motor/Actuator Initialization/Teach Process (Panoramic)
SUNROOF MOTOR/ACTUATOR INITIALIZATION/TEACH PROCESS (PANORAMIC)
INITIALIZATION PROCEDURE
Complete the Initialization Procedure whenever voltage has been applied to the control unit for the first time.
1. Hold the sunshade switch in the close position.
2. With the sunshade switch held closed, turn the rotary glass switch to the full open position and then to the full close position. Wait until both the
sunshade and the windows close and remain closed for approximately 2 seconds.
3. Both the window and the sunshade drives, the motor and the controller, will stall at the full closed position. This is also known as the hard stop
position. The initialization, or close stop, position is saved in electronically erasable programmable read-only memory (EEPROM).
IMPORTANT: The Initialization Procedure is not complete if one of the following events occurs before the initialization cycle has finished:
-
The rotary switch does not remain in the closed position.
-
The sunshade switch is released from the closed position.
-
Ignition and/or battery power has been removed.
-
If the Initialization Procedure is not carried out completely, it must be started over again.
TEACH PROCEDURE
IMPORTANT: Activate the Teach Procedure within 6 seconds after Initialization.
