pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 17443 > < Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 17441
Page 17
background image

The headliner may rub on a pair of plastic screw boss holes (empty/no screws in these bosses) that are part of the sunroof module on each side of the
module towards the front (refer to figure 25). 

Correction
Figure 26

For vehicles built before May 9, 2005, (Note: vehicles built after May 9, 2005, already has this update) partially lower the front of the headliner enough
to access this area, being careful not to bend or damage the headliner while performing the following procedure. Install a 102 mm X 102 mm (4 in X 4
in) felt/flocking tape* patch to the backside of the headliner, just under the pair of plastic screw boss holes (empty/no screws in these bosses) that are
part of the sunroof module on each side of the module (driver/passenger) towards the front (refer to figure 26). 

VERIFY CUSTOMER COMPLAINT HAS BEEN ELIMINATED Reinstall the headliner. *The felt/flocking tape, BSR P/N KT13296, can be
purchased from Kent Automotive by calling 1-800-654-6333 (in Canada, 1-800-563-1717).

Condition # 11

Condition #11

Some customers may comment of a squeak or itch noise over bumps at the rear of the sunroof.

Cause

Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 17443 > < Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 17441