G6 L4-2.4L (2007)
12. IMPORTANT: The sunroof window actuator cover conceals the window actuator screws. Use care when lifting up on the corners of the sunroof
window actuator side cover to expose the screws. Use care not to break off the end tabs.
Lift the trim covers corners to expose the attachment screws.
13. Loosen the four attachment screws (two on each side).
14. From outside the vehicle, slide the window panel forward a small amount.
15. Have an assistant push down on the front corner of the sunroof window panel using the palm of their hand while tightening the attachment screws,
one side at a time.
16. Adjust the other sunroof window panels as necessary to ensure 4 mm gap between them. Refer to Sunroof Window Height and Opening Fit
Adjustment (C3Y) Sunroof Window Height and Opening Fit Adjustment (CF5) and Sunroof Window Alignment. See: Adjustments See:
Adjustments
17. It is always desirable to have the front edge lower than the rear edge of the window panel in font of it to create a slight shingle effect - it should be
almost undetectable.
18. On extreme cases, where adjustment of the first sunroof window panel will not compensate for the puckers (1) in the seal, It will be necessary to
correct the puckers.
