G6 L4-2.4L (2007)
Locate the seam of the current seal and it's location, with tape or a grease pencil mark the roof.
6. Remove the seal from the sunroof module frame by pulling the seal away at one point and continuing around the perimeter of the frame.
7. Wipe the perimeter of the frame area with a clean, dampened cloth using window cleaner GM P/N 1050427 (Canadian P/N 992727) or equivalent
in order to clean the surface of the perimeter. Allow to air dry.
INSTALLATION PROCEDURE
1. If reusing the old sunroof window seal, use a clean dampened cloth, wipe the seal with a small amount window cleaner GM P/N 1050427
(Canadian P/N 992727) or equivalent to installation.
2. Cycle the sunroof to closed position.
3. Position the seam of the new seal into the channel previously marked in (step#5).Press the seal firmly into the channel until fully seated.
4. Starting in the rear corners of the seal channel, firmly press the window seal (1) into place, working any excess seal length toward the center,
seating the remainder of the seal across the rear of the sunroof opening.
5. Cycle the sunroof to the full open position.
6. Firmly press the seal into the front corners of the channel, and then work any excess length toward the center across the front and sides of the
