G6 L4-2.4L (2007)
opening
7. IMPORTANT: Ensure that the seal is properly seated around the entire perimeter of the frame.
Inspect the sunroof seal for rolling condition along the edges of the roof. Repair the rolling seal by spooning the edge of the seal into position to
the frame, using a suitable tool.
-
Open the sunroof and inspect the four corners of the seal for puckers or dimples.Repair the corners by pulling the seal tight and refitting to the
frame.
-
If the sunroof window seal is above the roof line it must be refitted into the frame and seated.
8. Install the sunroof window to the rear.
9. Install the sunroof window to the front.
10. Adjust the window panel. Refer to Sunroof Window Height and Opening Fit Adjustment (C3Y) Sunroof Window Height and Opening Fit
Adjustment (CF5). See: Adjustments See: Adjustments
11. Inspect sunroof for proper operation.
Sunroof Window Seal Roll Repair
SUNROOF WINDOW SEAL ROLL REPAIR
ADJUSTMENT PROCEDURE
1. Close the sunroof window panels.
2. IMPORTANT: Wind/whistle noise, air leaks and possible water leaks on the C3Y panoramic sunroof when closed. The easiest way to identify
the location of the air leak is to use a rubber hose against your ear in order to listen for the air leak. Using a rubber hose, 1/2 inch diameter 3 feet
long, listen around all the sunroof window sealing locations while all the door, windows and the sunroof window panels are closed, with the
HVAC blower on high. It should be note that some leakage will be heard at the "T" (1) joints on vehicles without a customer complaint.
IMPORTANT: If the sunroof window seal was rolled over during the installation causing inadequate sealing against the sunroof window
opening. This condition can be corrected by "fluffing" the seal.
Inspect the sunroof window seal for being rolled (1) over in area.
3. Inspect the sunroof window seal for the incorrect conditions below:
