pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 18238 > < Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 18232
Page 1
background image

Technical Service Bulletin # 05-08-67-014M

Date: 090828

Body - Panoramic Sunroof Noise Issues Diagnostic/Repair

INFORMATION

Bulletin No.: 05-08-67-014M

Date: August 28, 2009

Subject: General Guide to Panoramic Sunroof Noise Issues

Models:

2005-2007 Pontiac G6
2007 Saturn Aura

Supercede:
This bulletin is being revised to clarify the Parts information. Please discard Corporate Bulletin Number 05-08-67-014L (Section 08 - Body and
Accessories). 

Important
The intent of this bulletin is to identify the appropriate issue(s) and apply the appropriate correction(s) pertaining to the customer's comments.
To determine the final service labor operation time, use the initial base time and then apply the appropriate add times, depending on the issue
correction(s) performed. Please note - only the items performed on the vehicle being serviced should be used as the final repair time and the
Repair Order must indicate the Bulletin Number and the Condition Number(s) used.

Important
Do not
 replace an entire sunroof module for creak/pop type noise or wind noise-type complaints. A new sunroof module does not come as a complete
assembly and will require many components - including all of the glass panels - to be swapped over from the old module to the new module being
installed. Correctly following the bulletin should correct these concerns. 

Important
U.S. Dealer Technicians - Please review Tech Assist video 50250.17T1 at the GM Training web site prior to any repair of the panoramic
sunroof system. 

PLEASE VERIFY CUSTOMER CONCERN BEFORE SERVICE.

Important
If the sunroof motor/actuator assembly has been replaced, or has lost battery positive voltage or ground for any other reason, it will be
necessary to initialize the motor/actuator when service has been completed. Refer to Sunroof Control Module Programming and Setup in
Programming and Setup.

This bulletin covers the following issues:

-

Creak/snap/pop type noise coming from the sunroof module - Install mylar washers and lubricate all module fasteners (Refer to Condition #1) 

-

Windnoise coming from sunroof glass panels and/or HVAC blower whistle type noise that changes with fan speed - Install glass panel cross car
foam (Refer to Condition #2)

-

Windnoise coming from the sunroof module seal to roof - Install updated module seal (Refer to Condition #3)

-

Glass panel loose/rattling - (Refer to Condition #4)

-

Plastic/metal rattle type noise coming from the rear area of the sunroof module - (Refer to Condition #5)

-

Sunshade will not cycle (open or close) - (Refer to Condition #6)

-

Seal itch between glass panels - (Refer to Condition #7)

-

Intermittently the sunroof closes while opening - (Refer to Condition #8)

-

Light coming through at the rear corner of the glass panels - (Refer to Condition #9)

-

Headliner itch type noise at the front area, over the driver's and/or front passenger's head area - (Refer to Condition #10) 

-

Headliner squeak or itch noise at the rear of the sunroof - (Refer to Condition #11)

Parts Information

Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 18238 > < Body - Panoramic Sunroof Noise Issues Diagnostic/Repair|Page 18232