G6 L4-2.4L (2007)
3. Install the 2 brake pedal assembly to cowl mounting nuts.
Tighten the nuts to 15 N.m (11 lb ft).
4. Connect the brake pedal pushrod retaining clip (1) the wave washers (2) and the brake booster pushrod (3) to the brake pedal pin (4).
5. Install the steering column assembly to the vehicle.
6. Install the electrical connector to the brake apply sensor.
7. Install the closeout panel.
8. Install the knee bolster.
9. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.
