G6 L4-2.4L (2007)
10. Cap the brake pipe ends to prevent brake fluid loss and contamination.
11. Plug the modulator brake pipe openings to prevent brake fluid loss and contamination.
12. Remove the 4 insulator bolts on the brake pressure modulator valve bracket.
13. Remove the brake modulator valve from modulator bracket by pulling straight up.
Installation Procedure
Important: When installing a new brake modulator assembly, do NOT remove the shipping plugs from the pipe ports until after installation
into the vehicle.
1. Install the brake modulator valve to the modulator bracket.
Notice: Refer to Fastener Notice .
2. Install the 4 brake pressure modulator valve bracket insulator bolts.
Tighten the bolts to 10 N.m (86 lb in).