G6 L4-2.4L (2007)
Notice: Refer to Fastener Notice.
1. Install the NEW stud into the bearing/hub assembly.
Add enough washers (1) in order to draw the stud into the hub.
2. Install and tighten a wheel nut (2) until the head of the wheel stud is fully seated against the back of the bearing hub flange.
3. Remove the wheel nut (2) and the washers (1).
4. Install the brake rotor, and install the brake caliper and bracket as an assembly.
5. Install the tire and wheel assembly.
6. Lower the vehicle.