G6 L4-2.4L (2007)
Important: To ensure seal is properly seated, inspect the 4 tabs on the seal from the engine side of the seal. Do NOT twist or squeeze the
seal during installation.
2. Seat the intermediate shaft seal by pushing forward from the inside of the vehicle, until all four tabs of the seal are fully seated.
3. Connect the new intermediate shaft to the steering column shaft.
Notice: Refer to Fastener Notice.
4. Install the new steering column pinch bolt to the intermediate shaft.
-
For electronic power steering, tighten the bolt to 49 N.m (36 lb ft).
-
For hydraulic power steering, tighten the bolt to 62 N.m (46 lb ft).
5. Connect the intermediate shaft to the steering gear shaft.
6. Install the new steering gear pinch bolt to the intermediate shaft.
Tighten the bolt to 49 N.m (36 lb ft).
7. Install the left front wheel.