G6 L4-2.4L (2007)
6. Install the lower shock to knuckle bolt.
Tighten the lower shock to knuckle bolt to 180 N.m (133 lb ft).
7. Tighten the bolts and nuts in the following sequence:
^
Tighten the upper control arm to knuckle bolt and nut to 110 N.m (81 lb ft) plus 70 degrees rotation.
^
Tighten the lower control arm to knuckle bolt and nut to 60 N.m (44 lb ft) plus 70 degrees rotation.
^
Tighten the lower control arm to support bolt and nut to 110 N.m (81 lb ft).
^
Tighten the toe link to knuckle bolt and nut to 110 N.m (81 lb ft) plus 70 degrees rotation.
8. Install the wheel bearing/hub assembly.
Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
9. Remove the supporting wire and position the brake caliper and bracket assembly onto the knuckle.
10. Connect the rear park brake cable to the park brake actuator.
11. Install the rear tire and wheel assembly.
12. Lower the vehicle.
13. Perform a vehicle wheel alignment. Refer to Measuring Wheel Alignment.
