G6 L4-2.4L (2007)
Wheel Hub: Service and Repair
Rear Suspension
Rear Wheel Bearing and Hub Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the brake rotor.
4. Disconnect the electrical connector from the wheel speed sensor, if equipped with ABS.
5. Remove the stabilizer link bolt at the knuckle and position the stabilizer link out of the way in order to provide access to the wheel bearing/hub
nuts. Refer to Stabilizer Shaft Replacement.
6. Remove the 4 wheel bearing/hub assembly nuts.
7. Remove the wheel bearing/hub assembly from the knuckle.
Installation Procedure
1. Install the wheel bearing/hub assembly to the knuckle.
Notice: Refer to Fastener Notice.
2. Install the 4 wheel bearing/hub assembly nuts.
Tighten the nuts to 63 N.m (47 lb ft).
3. Connect the stabilizer link bolt at the knuckle. Refer to Stabilizer Shaft Replacement.
