G6 L4-2.4L (2007)
^
The bottom pan removal capacity is approximately 6.5 L (6.9 qt).
^
The complete overhaul capacity is approximately 9 L (9.5 qt).
^
The dry capacity is approximately 12.2 L (12.9 qt).
8. Start the engine, warm up the transaxle, and check for leaks.
9. Inspect for proper fluid level. Refer to Transmission Fluid Checking.
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
10. Reset the TAP values. Refer to Transmission Adaptive Functions.
Intermediate/Fourth Servo Assembly Replacement
Intermediate/Fourth Servo Assembly Replacement
Removal Procedure
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a
hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
1. Position the vehicle on a hoist and raise the vehicle. Refer to Vehicle Lifting.
2. Remove the oil pan. Refer to Oil Pan Replacement.
3. Remove the oil level control valve. Pull the valve straight down. Do not pry on the valve.
4. Remove the oil filter and oil filter O-ring seal. The seal may stay in the case when the filter is removed.
Important: Do not score or damage the transaxle case when removing the filter neck seal.
5. Using a chisel, indent the top of the filter neck seal to relax the press fit.
