G6 L4-2.4L VIN B (2006)
4. Align the manifold plate bolt holes to the holes on the new pump. This will ensure that the cylinder hoses are placed in the correct port.
5. Align the cylinder hoses into each port and push down until the hoses are seated properly in the hydraulic pump manifold.
6. Push down on the manifold plate (1) and verify that all of the cylinder hoses are seated properly.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the bolts to 10 N.m (89 lb in)
Apply Loctite(R) Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
7. Connect the electrical connectors to the hydraulic pump.
8. Install the nuts that attach the pump to the floor pan.
Tighten the bolts to 18 N.m (13 lb ft).
9. Connect the sunroof solenoid harness.
10. Connect the electrical connectors to the control module.
