G6 L4-2.4L VIN B (2006)
Lubricate all seals (refer to illustrations above) with GM Dielectric Silicone Grease.
Condition 5
Noise over bumps from top of the quarter panel and the base of the window (either side of vehicle).
Cause 5
The rear quarter panel window belt molding may be making a clicking/snapping noise.
Correction 5
PROCEDURE FOR VEHICLES BUILT PRIOR TO 10/12/2006
Remove the window belt molding and clean the flange of the quarter panel with alcohol. Install three pieces of BRS Tape (flocking tape) to the flange
and install the belt molding as shown above.
Condition 5A
Snapping noise from the rear quarter panel/roof area when cycling top open (either side of vehicle).
Cause 5A
This condition may be due to contact between the rear roof panel trim and the quarter panel upper trim.
Correction 5A
