G6 L4-2.4L VIN B (2006)
Connect the S14 pigtail connector (1).
Wrap the line bundle to the hoses with the foam tape.
When snapping the rod ends back onto the ball studs, make sure that the rods and sockets are aligned squarely to the ball studs. Do not rotate the rod and
socket in either direction on the ball stud. If the rod and socket are rotated in either direction on the ball stud, the top will bind when you lower or lift the
top.
Connect the right and left rod ends from the header latches to the ball studs.
Open the roof using the switch on the header. Proceed to the section below titled, "Roof Functional Test".
Move the roof top to the service position and install the top restraining straps, BO 48120. Refer to Folding Top Retaining Strap Installation procedure in
