G6 L4-2.4L VIN B (2006)
1.
When snapping the rod ends back onto the ball studs, make sure that the rods and sockets are aligned squarely to the ball studs. Do not rotate the
rod and socket in either direction on the ball stud. If the rod and socket are rotated in either direction on the ball stud the top will bind when you
lower or lift the top.
2.
Check the top for proper operation by using the switch on the header and running the top completely down into the trunk and completely closed
again at the header. If the top operates correctly, run the top just enough for the roof to unlatch at the header and move up slightly, and then
reverse the switch latch roof at the header again so that the "Top Move Complete" message appears on the radio display. Do this sequence 2-3
times to verify top operation.
^
If the top operates correctly, install the headliner. Proceed back to Step 20.
^
If the top will not operate correctly, verify that the S18 switch, which is activated by the latch hook, is not being made at the left header latch.
