G6 L4-2.4L VIN B (2006)
3. Lift the trim covers corners to expose the attachment screws.
IMPORTANT: The sunroof window actuator cover conceals the window actuator screws. Use care when lifting up on the corners of the sunroof
window actuator side cover to expose the screws. Use care not to break off the end tabs.
4. Loosen the four attachment screws (two on each side).
5. Do this from outside of the vehicle, slide the sunroof window panel forward or rearward to achieve 4 mm spacing between the window panels.
Refer to Sunroof Window Height and Opening Fit Adjustment (C3Y) Sunroof Window Height and Opening Fit Adjustment (CF5).
IMPORTANT: In most cases it is found that only one sunroof window panel, or one side of one sunroof window panel is out of position. Adjust the
other sunroof window panels as necessary to ensure 4 mm gap between them.
6. Use an assistant to push down on the corner of the sunroof window panel using the palm of their hand while tightening the attachment screws, one
side at a time.
IMPORTANT: It is always desirable to have the front edge lower than the rear edge of the window panel in front of it to create a slight shingle
effect.
7. Inspect the sunroof window panels for proper operation.
