G6 L4-2.4L VIN B (2006)
Approximate compensator barrel location after tightening during reinstallation process.
3. Reinstall the front four compensators per the following procedure. Spin all front four compensator barrels all the way down (refer to figure 3 A,
B).Figure 4A
Figure 4B
Important
To achieve proper seal to body compression, have one person push firmly upward on the black rail of the module between the two front
center compensators as another person tightens the center two compensators (refer to figure 4A). This will improve the seal contact along
the front edge of the module to body. Then reinstall the two outboard tolerance compensators to the roof. (Torque specification 10 Nm/89
lb in) (refer to figure 4B)
Figure 5
