G6 L4-2.4L VIN B (2006)
6.
Move each lower track forward until an audible noise is heard, indicating that the track is fully locked.
7.
At this stage both manual tracks are aligned.
8.
Measure the overhang from the front edge of the plastic end cap (1) on the lower track to the front edge of the upper track (2). Measurement for
each track must be 138 mm or as close as possible.
9.
Install the seat in the vehicle without touching the adjuster handle. Then tighten the rear bolts prior to any track adjustment.
10.
While sitting in the seat, cycle the tracks fore/aft and lock the tracks at different positions. Check to see whether the tracks are aligned.
11.
Visually inspect the tracks, adjust the upper tracks flush with the front of the lower tracks. Check that the configuration in locked position is
identical for both inboard (1) and outboard tracks (2).
Disclaimer
