G6 L4-2.4L VIN B (2006)
1.
Place the NEW cylinder bore sleeve onto the cylinder block.
2.
Install EN 45680-851 fixture and EN 45680-853 cylinder bore sleeve installer assembly over the cylinder bore sleeve and onto the cylinder block.
Do not apply downward pressure to the cylinder bore sleeve.
Note:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints,
lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
Important:
Use 4 old cylinder head bolts for the attaching bolts.
3.
Insert the 4 attachment bolts into the legs of the EN 45680-851 fixture (1). Do not apply downward pressure to the cylinder bore sleeve (2).
Tighten the 4 attachment bolts to 15 N.m (11 lb-ft).
