G6 L4-2.4L VIN B (2006)
4. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the body control module fuse center (1).
5. Use caution while reaching in and turn the ignition switch to the ON position. The AIR BAG indicator will flash then turn OFF.
6. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures
SIR Disabling and Enabling Zone 9
SIR DISABLING AND ENABLING ZONE 9
DISABLING PROCEDURE
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Place the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Locate the body control module fuse center then remove fuse center cover.
5. Locate and remove the AIR BAG (IGN) and AIR BAG (BATT) fuses from the body control module fuse center.
IMPORTANT: This SDM has two fused power inputs. To ensure there is no unwanted SIR deployment, personal injury, or unnecessary SIR system
repairs, remove both AIR BAG (IGN) and AIR BAG (BATT) fuses from the body control module fuse center. With the AIR BAG fuses removed and
