G6 L4-2.4L VIN B (2006)
Body Control Module: Service and Repair
BODY CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the right console trim panel.
3. Remove the body control module (BCM) screws.
4. Remove the BCM wire harness connectors.
5. Remove the BCM.
INSTALLATION PROCEDURE
1. Install the BCM.
2. Install the BCM wire harness connectors.
3. Install the BCM screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 2.5 N.m (22 lb in).
4. Install the right console trim panel.
5. Connect the negative battery cable.
6. For a new or remanufactured BCM, program the BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration.
7. Program the BCM after replacement. Refer to Control Module References. See: Testing and Inspection/Programming and Relearning
