G6 L4-2.4L VIN B (2006)
1. Slide the ECM into the bracket on the front of the battery box.
2. Push down on the ECM until the retaining tab snaps into place.
3. Connect the ECM harness connectors.
4. Connect the negative battery cable.
NOTE: Refer to Fastener Notice.
Tighten the bolt to 17 N.m (13 lb ft).
5. Reset the clock and preset radio stations.
6. If a NEW ECM was installed, the ECM must be programmed. Refer to Control Module References. See: Testing and Inspection/Programming
and Relearning