G6 L4-2.4L VIN B (2006)
the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system
malfunction.
6. Remove the connector position assurance (CPA) (1) from the RF/passenger side impact module yellow connector (3) which is located under the
passenger seat.
7. Disconnect the vehicle harness yellow connector (2) from the RF side impact module yellow connector (3).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. Connect the vehicle harness yellow connector (2) to the RF side impact module yellow connector (3).
3. Install the CPA (1) to the RF side impact module yellow connector (3).
4. Install the AIR BAG (IGN) and AIR BAG (BATT) fuses into the body control module fuse center (1).
5. Use caution while reaching in and turn the ignition switch to the ON position. The AIR BAG indicator will flash then turn OFF.
6. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and
Associated Procedures
