G6 L4-2.4L VIN B (2006)
13. Connect the appropriate pigtail adapter (2) to the SIR deployment harness (1).
14. Extend the SIR deployment harness and adapter to full length from the deployment fixture.
15. Connect the seat belt pretensioner connector to the adapter on the deployment harness.
16. Clear the area of people.
IMPORTANT: When deploying a seat belt retractor pretensioner, the rapid expansion of gas is very loud. Notify the people in the immediate area
that a seat belt pretensioner will be deployed.
17. Separate the 2 banana plugs on the SIR deployment harness.
18. Place a 12 V minimum/2 A minimum power source, such as a vehicle battery, near the shorted end of the harness.
IMPORTANT: When the seat belt retractor pretensioner deploys, the deployment fixture may jump about 30 cm (1 ft) vertically. This is a normal
reaction of the seat belt pretensioner due to the force of the rapid expansion of gas inside the pretensioner.
19. Connect the SIR deployment harness wires to the power source. Seat belt pretensioner deployment will occur when contact is made.
20. Disconnect the SIR deployment harness from the power source after the seat belt retractor pretensioner deploys.
