G6 L4-2.4L VIN B (2006)
1. Apply the thread sealant GM P/N 12345382 (Canadian P/N 10953489), or equivalent to the sensor threads.
IMPORTANT: Tap out the sensor mounting hole in the engine head to remove any thread sealant residue. Clean any sealant residue from the old
sensor and apply the RTV sealant to threads if old the sensor is going to be reused.
NOTE: Refer to Fastener Notice.
2. Install the ECT sensor.
Tighten the sensor to 20 N.m (15 lb ft).
3. Connect the ECT sensor electrical connector (1).
4. Fill the cooling system as needed. Refer to Draining and Filling Cooling System. See: Engine, Cooling and Exhaust/Cooling System/Service and
Repair
